Need help?Do you have a question about the d&b audiotechnik 30D and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| Amplifier Technology | Class D |
| Signal to Noise ratio (unweighted) | > 100 dB |
| THD+N/Total Harmonic Distortion | < 0.1 % |
| Frequency Response | 20 Hz - 20 kHz |
| Sampling rate | 96 kHz |
| Equalization | Parametric EQ |
| Input Impedance | 20 kOhms (balanced) |
| Mains Voltage | 100 - 240 V, 50 - 60 Hz |
| Networking | Ethernet |
| Connectors | XLR |
| Output Connectors | SpeakON |
Explains lightning and exclamation point symbols and lists essential safety precautions for operation and installation.
Details rear panel connectors like Mains, Ethernet, Audio I/O, CAN, GPIO, FAULT.
Describes front panel power switch, reset button, and status LEDs.
Details how to perform a system reset using the dedicated button.
Guides on connecting the amplifier to a computer via Ethernet and setting static IPs.
Explains interaction methods (Web Remote, R1) and cursor types (Position, Edit).
Details how to change values using the Edit dialog and OK/Cancel buttons.
Explains how to back up and restore the amplifier's settings via the Service tab.
Illustrates the signal path through filters, EQ, delay, and amplifier.
Explains the meaning of Green, Yellow, and Red LEDs for signal status and errors.
Explains OSP, GR, and OVL indicators and their meanings.
Guides on performing system reset and defining input/output modes.
Guides on selecting speaker setups and configuring remote settings.
Details how to configure individual channel settings like CUT, HFA, CPL, Level.
Explains how to enter or edit the device name using the input mask.
Details input modes, signal path, and analog/digital input activation.
Covers digital input sync requirements, status messages, and system clocking.
Explains how input monitoring detects pilot signals and reports errors.
Describes the fallback function for signal path redundancy.
Explains assigning output modes like Dual Channel, Mix TOP/SUB, 2-Way Active.
Guides on setting IP address, mask, gateway, and IP mode (Manual, DHCP+FB).
Explains GPIO modes (Input/Output) and assigning functions.
Describes User, Alarm, Backup AmpPresets and functions like Select, Name, Recall.
Details enabling AutoStandby and AutoWakeup, time, threshold, and input selection.
Details filter types (CUT, HFA, CPL, CSA) and their settings.
Explains EQ overview, layers, and functions like On/Off, Edit, Clear, Copy/Paste.
Explains delay function, On/Off, time adjustment, and units.
Details selecting input sources for channels and accessing Input mode.
Explains the System check tool, calibration process, and impedance measurement.
Details running the system check and its purpose for verifying system setup.
Explains Load monitoring for detecting loudspeaker malfunctions and its limitations.
Explains how to activate LoadMatch and set parameters like cable length, count, and cross-section.
Describes the LINEAR setup for using the amplifier as a linear power amplifier.
Explains linking channel EQ and Delay settings and direction modes.
Details the signal generator for sine/pink noise, its uses, and On/Off status.
Explains measurement references and provides power draw data for 10D amplifier.
Warns about lithium battery explosion risk and refers to qualified service personnel.
Lists error IDs, display text, description, location, and possible reasons for errors.
To Next Page
