Step 1
Step 3
Step 2
Step 4
1. Select the channel EQ you want to copy.
2. Select «Copy».
↳
The «Paste» button becomes accessible.
3. Select the channel to which you want to paste the EQ settings.
4. Select «Paste».
EQ layer/curve
Apart from the overall frequency response, the following functions
and status indicators are provided:
Header section
EQ [n] -
On/Off
On/Off status of the corresponding EQ.
This field also acts as On/Off switch for the
respective EQ.
Data section
Line by line from left to right:
Band selector
Allows the selection of a filter band from the
Filter band bar using the «Value +/–» buttons.
Filter band
bar
Displays all filter bands that are in use while
the number of remaining filter bands is
indicated next to the bar on the right.
Band On/Off Switches the selected filter band on or off.
Type Depending on the filter type used, 1 to 4
bands may be required for each filter.
The following table lists the available types,
their corresponding parameters and the
number of filter bands required for the selected
type.
d&b 10D/30D Manual 1.10 en64
To Next Page
Loading...
