D&H PD05A - Page 41

41
Fahrzeug-/Funktionsdecoder ab Firmware-Version 1.11
41
Locomotive/Locomotive function decoder from firmware version 3.12
CV
Name and definition Range
Standard
41 Function mapping F7 (see supplement 1) 0-255 0
42
Function mapping F8 (see supplement 1)
0-255 64
43
Function mapping F9 (see supplement 1)
0-255 0
44
Function mapping F10 (see supplement 1)
0-255 0
45
Function mapping F11 (see supplement 1)
0-255 0
46
Function mapping F12 (see supplement 1)
0-255 0
47
Function mapping F1 (r) (see supplement 1)
In case CV47 should have a different value than CV35,
you have to set CV35 first and then CV47
0-255 4
48
Speed step characteristic
(see supplement 2)
Deflection of the speed step characteristic, 0 = linear ... 7 = strongly curved
0-7 5
49
Impulse width
(not relevant to FH*)
0 = 1 ms, 1 = 2 ms, 2 = 4 ms, 3 = 8 ms
0-3 1
50 Control variant
(not relevant to FH*)
0 = defined by CV56 - CV59, 1 = hard, 2 = soft, 3 = very soft
0-3 2
51 Interchange of connections
Bit
Function Value
0........ Motor connections ................................ 1
(not relevant to FH05B/FH18A/FH22A)
1........ Light connections .................................. 2
2........ Track connections ................................. 4
0-7 0
BA DH engl FW3_12 Druck.indd 41BA DH engl FW3_12 Druck.indd 41 10.05.21 14:2710.05.21 14:27