Dane Technologies, Inc. WheelChair Mover Owners Manual 35
7105 Northland Terrace, Minneapolis, MN 55428 / 888-544-7779 / 763-544-7779 / Fax 763-544-4234
www.danetechnologies.com 970-068 6/19/17 Rev F
WARNING
Do not use extension cords. Use the cord supplied
with the machine. Find a location for charging,
which is close to an electrical outlet receptacle.
1) Before using the battery charger, read all instructions and cautionary marking related
to the:
Battery charger
Battery
2) CAUTION: To reduce risk of injury, charge only 2-12 volt sealed lead acid (AGM)
type rechargeable batteries. Other types of batteries will void warranty and may
burst causing personal injury or damage.
3) Do not expose charger to rain, snow or other moisture sources.
4) CAUTION: To prevent the risk of fire, use the charger only in dry and ventilated
rooms without flammable fluids and explosive gases.
5) To reduce the risk of damage to the electric plugs and cord, pull by the plug rather
than the cord when disconnecting the charger.
6) Make sure cord is located so that it will not be stepped on, tripped over or otherwise
subject to damage or stress.
7) Do not operate charger with damaged cord or plug – replace immediately.
Replacement should only be completed by Dane Technologies or an authorized
service technician.
8) Do not operate a charger if it received a sharp blow, has been dropped or otherwise
damaged in any way.
9) Do not disassemble charger!
10) To reduce risk of electric shock, unplug charger from AC outlet and battery outlet
before attempting any maintenance or cleaning.
To Next Page
Loading...