Dane Technologies, Inc. WheelChair Mover Owners Manual 77
7105 Northland Terrace, Minneapolis, MN 55428 / 888-544-7779 / 763-544-7779 / Fax 763-544-4234
www.danetechnologies.com 970-068 6/19/17 Rev F
Wheelchair Mover Trainee Quiz
Your Name: _________________ Date: ____________ Location: _____________
1. Never operate faster than conditions, obstacles, and patient safety and comfort permit.
True _____ False _____
2. Slow down when making turns. True _____ False _____
3. When approaching people proceed toward them at your normal operating speed.
True _____ False _____
4. The brake on the WheelChair Mover is applied by releasing the throttle lever.
True _____ False _____
5. Before beginning to use the WheelChair Mover, be sure to check (select only one)
A. Hitch/jaws for proper operation.
B. Battery charge level is greater than 20%.
C. Steering for proper control.
D. Brake for proper operation.
E. Tires for proper rolling and wear.
F. All of the above.
6. When operating the WheelChair Mover, it’s acceptable to ride on the WheelChair Mover.
True _____ False _____
7. When driving up to a wheelchair to connect it, make sure the WheelChair Mover is:
A. Moving in reverse
B. Operated with one hand
C. In the ““turtle”” speed
D. In the “rabbit” speed
8. Back down ramps when transporting patients. True______ False________
9. The WheelChair Mover is to be left unattended or in storage, turn it “O”.
True_____ False_____
Figure 1 For each item below, identify its
location on the control panel in Figure 1 and
write the appropriate letter next to the item.
ITEM DESCRIPTION Letter
10. Back-Away Button
11. Emergency Off control
12. Forward/Reverse Throttle
13. "O/I" Switch
14. Hitch Handle
15. Battery Level Indicator
16. Controller Status LED
17. Horn Switch
Number Correct:
---------------------------------------------------------------------------------------------------------------------
To be completed by trainer. PERFORMANCE TRAINING
Observe the employee perform the following tasks and indicate if he/she displayed acceptable operation.
For successful completion of training employee must display ability to properly perform all three operating
tasks:
Control Panel Use Driving of WheelChair Mover Transporting wheelchairs
Ok ____ Unacceptable _____ Ok ____ Unacceptable _____ Ok ____ Unacceptable ____
Trainer: Date:
If performance training was not successfully completed, do not allow the employees to operate the
machine on their own until retrained and re-evaluated. If re-evaluated, make note below.
Note:
To Next Page
Loading...