Danfoss AK-CH 650

50 Capacity controller RS8ER302 © Danfoss 2016-02 AK-CH 650
System setup
1. Go to Conguration menu
2. Select System setup
3. Set system settings
Conguration - continued
All system settings can be changed by pressing in the blue eld with the
setting and then indicating the value of the required setting.
In the rst eld you enter a name for what the controller will be control-
ling.
When the time is set the PC’s time can be transferred to the controller.
When the controller is connected to a network, date and time will
automatically be set by the system unit in the network. This also applies
to change-over Daylight saving.