Danfoss DEVIreg 850 IV - Page 17

DEVIreg™ 850 IV
17Installation instruction
Installation of ground system
The installation of a DEVIreg™ 850 with 1 ground system has been selected.
It is optional if the sensors are connected to the DEVIreg™ 850 before power on or during
the installation.
The system uses the output System A.
If sensors for System A are not connected — do it now!
Press or wait…
CONNECT SENSORS:
SYSTEM A
System is being scanned to find type of connected
sensors…
SYSTEM A
SCANNING...
Select system type: Ground.
SYSTEM TYPE:
GROUND
Wait until correct number of sensors for System A
is found.
3 GROUND SENSOR
FOUND. ACCEPT?
Press when all sensors are found…
System A is installed…
SYSTEM A!
INSTALLED
System is being checked…
CHECKING SYSTEM
<>
Press to configure System A (naming sensors
and changing factory settings).
CONFIG SYSTEM:
SYSTEM A
Please refer to “Changing parameters and performance of systems” in “User Manual”
for description of the configurable parameters.
If for some reason you do not wish to configure the system now you can press
to skip configuration of system.
Press to end configuration.
PRESS  TO END
CONFIGURATION.