5.9 Operating Data
Operating Data
Software version
XXXX
Software version of the sensor head.
Operating Data
SC X
Days of Operation
expected XXX
This menu is for retrieving relevant operational data from the sensor head.
No changes or modifications are possible.
Operating Data
SC
Expected remaining lifetime (in days) of
the sensor head.
Days of Operation
X Days
Current days of operation.
Min. Temperature
25 °C
Display of the lowest temperature
detected by the device.
Max. Temperature
25 °C
Display of the highest temperature
detected by the device.
Maintenance Days
remaining XXXX
Days until the next calibration is due.
Days of Operation
Last XXX
Days of operation since the last
calibration took place.
If more than one sensor head is connected to
the DGS, the selection is done at X.
Number of Calib.
X
How many times the sensor head has
been calibrated.
Sensitivity
XXX%
Remaining sensitivity of the sensor.
Must be replaced when below 35%. The
value is only updated immediately after
calibration.
User Guide | Danfoss Gas sensor, type DGS
© Danfoss | Climate Solutions | 2022.01 BC291049702513en-000201 | 17
To Next Page
Loading...
