Danfoss DGS Series - Calibration

5.10 Calibration
Zero DP 1
DP 1
Sxxx R744 ppm
Calibration gas
XXXX ppm
This section gives an overview of the calibration menu.
The calibration description can be found on the following pages.
For HFC, remember to use the specified calibration gas.
(HFC grp 1 = R1234yf, grp 2 = R134a, grp 3 = R407c)
Calibrate
Set the test gas concentration.
Gain DP 1
Burn clean
Selection of the
sensor head to
be calibrated
Calibration AO 1
Only available for combustible gases
(propane).
Zero calibration.
See section 4.10.1
Gain calibration.
See section 4.10.2
See section 4.10.3
User Guide | Danfoss Gas sensor, type DGS
18 | BC291049702513en-000201 © Danfoss | Climate Solutions | 2022.01