Danfoss EKE 1C User Manual

Figure 48: Uploading the settings to EKE
Table 20: KoolProg main Menu Summary
Parameter Group
Setup description
Reference
Main switch, Mode selection
Control
General control parameter for example selecting control mode, protection function ext.., it is divided into 3
sections:
Control Basic, Control Advanced, Control heatpump
Defrost Sequence
Parameters about the defrost mode
Alarm conguration
Alarm parameters
IO cong
Confuguring For analog and digital inputs
Sensor’s conguration
Conguring pressure and temperature sensor
Valve Conguration
Congure settings for the valve
External reference conguration
For more settings for External reference and the AI4
Display
Display Settings of the MMI screen, and passwords and logout conguration
Communication
-Communication settings (controller address, communication baud rate for CANbus and Modbus)
-Signal Sharing settings
Service
Service Mode allows Entering
-Manual mode, Service Mode and Applying factory default.
4.2.4 Copy to device- Uploading conguration le to KoolProg:
From the parameter selection menu, any change made can be saved as le using the saving options, save or save as,
also you can know the folder containing these les by clicking the folder icon. To upload a conguration le. Click
on browse, select the le you saved from the parameter selection menu, then click open, then Start.
Figure 49: Uploading les through copy-to-device menu
Superheat controller, Type EKE 1A, 1B, 1C, 1D
© Danfoss | Climate Solutions | 2022.06 BC398828796060en-000101 | 36

Danfoss EKE 1C Specifications

General

Brand	Danfoss
Model	EKE 1C
Category	Controller
Language	English