Danfoss FC 300 Series User Manual

Contents
1 Introduction
1-1
1.1.1 Approvals 1-1
1.1.2 Symbols 1-1
1.1.3 Abbreviations 1-1
1.1.4 Definitions 1-2
1.1.5 Electrical Wiring - Control Cables 1-6
2 How to Program
2-1
2.1 The Graphical and Numerical Local Control Panels
2-1
2.1.1 How to Program on the Graphical LCP 2-1
2.1.2 The LCD Display 2-2
2.1.4 Display Mode 2-4
2.1.5 Display Mode - Selection of Readouts 2-4
2.1.6 Parameter Set-up 2-6
2.1.7 Quick Menu Key Functions 2-6
2.1.9 Main Menu Mode 2-8
2.1.10 Parameter Selection 2-8
2.1.14 Infinitely Variable Change of Numeric Data Value 2-9
2.1.16 Readout and Programming of Indexed Parameters 2-9
2.1.17 How to Program on the Numerical Local Control Panel 2-9
2.1.18 Local Control Keys 2-10
2.1.19 Initialization to Default Settings 2-11
3 Parameter Descriptions
3-1
3.2 Parameters: 0-** Operation and Display
3-2
3.3 Parameters: 1-** Load and Motor
3-12
3.4 Parameters: 2-** Brakes
3-27
3.5 Parameters: 3-** Reference / Ramps
3-32
3.6 Parameters: 4-** Limits / Warnings
3-42
3.7 Parameters: 5-** Digital In/Out
3-48
3.8 Parameters: 6-** Analog In/Out
3-66
3.9 Parameters: 7-** Controllers
3-75
3.10 Parameters: 8-** Comm. and Options
3-81
3.11 Parameters: 9-** Profibus
3-91
3.12 Parameters: 10-** DeviceNet CAN Fieldbus
3-98
3.13 Parameters: 12-** Ethernet
3-102
3.14 Parameters: 13-** Smart Logic Control
3-106
3.15 Parameters: 14-** Special Functions
3-119
Contents FC 300 Programming Guide
MG.33.MA.22 - VLT
®
is a registered Danfoss trademark

Danfoss FC 300 Series Specifications

General

Category	DC Drives
Enclosure	IP20
Communication Options	CANopen
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short Circuit
Input Voltage	380-500V AC