Danfoss FC 301

Par. No. #
Parameter description Default value 4-set-up FC 302
only
Change during
operation
Conver-
sion index
Type
10-0* Common Settings 10-00 CAN Protocol null 2 set-ups FALSE - Uint8 10-01 Baud Rate Select null 2 set-ups TRUE - Uint8
10-02 MAC ID ExpressionLimit2 set-ups TRUE0Uint8
10-05 Readout Transmit Error Counter 0 N/A All set-ups TRUE 0 Uint8
10-06 Readout Receive Error Counter 0 N/A All set-ups TRUE 0 Uint8
10-07 Readout Bus Off Counter 0 N/A All set-ups TRUE 0 Uint8 10-1* DeviceNet 10-10 Process Data Type Selection null All set-ups TRUE - Uint8 10-11 Process Data Config Write ExpressionLimit 2 set-ups TRUE - Uint16 10-12 Process Data Config Read ExpressionLimit 2 set-ups TRUE - Uint16
10-13 Warning Parameter 0 N/A All set-ups TRUE 0 Uint16
10-14 Net Reference [0] Off 2 set-ups TRUE - Uint8
10-15
Net Control [0] Off 2 set-ups TRUE - Uint8
10-2* COS Filters 10-20 COS Filter 1 0 N/A All set-ups FALSE 0 Uint16 10-21 COS Filter 2 0 N/A All set-ups FALSE 0 Uint16
10-22 COS Filter 3 0 N/A All set-ups FALSE 0 Uint16
10-23 COS Filter 4 0 N/A All set-ups FALSE 0 Uint16 10-3* Parameter Access 10-30 Array Index 0 N/A 2 set-ups TRUE 0 Uint8 10-31 Store Data Values [0] Off All set-ups TRUE - Uint8 10-32 Devicenet Revision ExpressionLimit All set-ups TRUE 0 Uint16
10-33 Store Always [0] Off 1 set-up TRUE - Uint8
10-34 DeviceNet Product Code ExpressionLimit 1 set-up TRUE 0 Uint16
10-39
Devicenet F Parameters 0 N/A All set-ups TRUE 0 Uint32
10-5* CANopen 10-50 Process Data Config Write. ExpressionLimit 2 set-ups TRUE - Uint16 10-51 Process Data Config Read. ExpressionLimit 2 set-ups TRUE - Uint16
4.3.11. 10-** CAN Ser. Com. Bus
4. How to Program
VLT
®
AutomationDrive FC 300 Instruction
Manual
68 MG.33.A9.22 - VLT is a registered Danfoss trademark
4