Danfoss Heating
7
GB
Option 8 - (Advanced Copy Functions)
Press NEXT, then + or - to change between the following copy
options:
(0) Standard copy in 7 day and 5+2 day.
(1) Enhanced copy in 7 day and 5+2 day.
(2) Enhanced copy in 7 day and AB copy in 5+2 day.
For an explanation of the copy features and how to use them please
see below.
Press PROG to return to RUN.
There are 3 possible copy functions available. These are; Standard
Copy, Enhanced Copy, and AB copy. Copy functions are enabled/
disabled in the Advanced Programming Options (page 6).
Standard Copy: Pressing copy will copy the previous days events
into the displayed day. The unit will then display the 1st event for the
new day. This copy function is present only if the unit is set to run in
5+2 or 7 day mode.
Enhanced Copy: The enhanced copy function is available in 7 day
mode only. This allows any day to be copied to any other day, or days.
To use the enhanced copy function go into the event programming
using the PROG button, then:
1. Use the DAY button to fi nd the day to be copied from.
2. Press the COPY button to select the day to be copied from. When
selected, the day should begin to fl ash.
3. Use the DAY button to fi nd the day to be copied to.
4. Press COPY button to copy the selected day.
5. Repeat steps 3 and 4 to select and copy other days.
6. To stop copying, use the DAY button to go back to the fl ashing
day and press the COPY button. The previously fl ashing day will
stop fl ashing to indicate it has been de-selected.
NOTE: When a day has been copied to, it will remain visible and not
fl ashing when the DAY button is used to select other days.
5.0 Copy Functions Explained
To Next Page
Loading...
Need help?
General
