NOTE
The used of point to point is recommended to increase the network performance. If listen only connection is used, multicast
has to be selected.
The Module Info – This tap holds generic information.
The Reset Module – This button will make a simulated Power-cycle of the frequency converter.
NOTE
For more information on the CIP class 1 Forward Open command, please refer to section: EtherNet/IP Connections under the
How to Control -chapter.
How to Configure MCA 121 EtherNet/IP
MG.90.J3.02 - VLT
®
is a registered Danfoss trademark 15
4 4
To Next Page
Loading...
