Danfoss PLUS+1 SC0XX-1 Series User Manual

General comments
Mating connectors
The SC Controller Family use Deutsch
®
connectors. Danfoss has assembled a mating connector kit,
referred to as a bag assembly, for the 24 and 50 pin module housings. Mating connector bag assembly
ordering information is found in the product data sheet for each module.
Deutsch
®
mating connector part information
Description 24 pin module 50 pin module
Crimp tool HDT48-00 (solid contacts) (20 to 24 AWG) HDT48-00 (solid contacts) (20 to 24 AWG)
DTT20-00 (stamped contacts) (16 to 20 AWG) DTT20-00 (stamped contacts) (16 to 20 AWG)
Contacts Solid: 0462-201-2031 (20 to 24 AWG) Solid: 0462-201-2031 (20 to 24 AWG)
Stamped: 1062-20-0144 (16 to 20 AWG) Stamped: 1062-20-0144 (16 to 20 AWG)
Connector plug Gray A-Key DTM 06-12SA Black B-Key DTM
06-12SB
DRC26-50S01
Wedge WM-12S Not required
Strip length 3.96 to 5.54 mm [0.156 to 0.218 in] 3.96 to 5.54 mm [0.156 to 0.218 in]
Rear seal maximum insulation OD 3.05 mm [0.120 in] 2.41 mm [0.095 in]
Sealing plugs 0413-204-2005 0413-204-2005
Danfoss mating connector part information
Description 24 pin module 50 pin module
Mating connector bag assembly (20 to 24 AWG) 10100945 10100946
Mating connector bag assembly (16 to 20 AWG) 10102023 10102024
Danfoss crimp extraction tool part information
Description Part number
Crimp tool for 20 to 24 AWG 10100745
Crimp tool for 16 to 20 AWG 10102028
Extraction tool Deutsch 114010; 12 AWG 11068808
Extraction tool Deutsch 0144-240-2005; 16 to 20, 20 to 24 AWG 10100744
PLUS+1
®
module mating connectors may be mated 10 times.
Recommended torque for the Deutsch
®
mating connector retaining fastener on the 50 pin connector is
2.26 N•m (20 lb•in).
Product installation
Mounting
PLUS+1
®
modules can be mounted in one of three ways:
•
End (bulkhead) installation
•
Up to 3 units stacked on one another
•
Individually side mounted
In each case, care must be taken to insure that the module connector is positioned so that moisture
drains away from the connector. If the module is side or stack mounted, provide a drip loop in the
Technical Information
PLUS+1 SC0XX-1XX Controller Family
Product installation and start-up
22 |
©
Danfoss | June 2016 L1415500 | BC00000235en-US0201

Danfoss PLUS+1 SC0XX-1 Series Specifications

General

Brand	Danfoss
Model	PLUS+1 SC0XX-1 Series
Category	Controller
Language	English