Danfoss PLUS+1 - Rotary Switch Calibration; Rotary Switch Time Ramp

Technical Information Transit Mixer Controller (TMC)
11061324 • Rev CA • Sep 2013
15
Rotary Switch Calibration
This screen is used to calibrate the rotary dial.
1. Click the start calibration button and turn the switch to neutral and the end positions.
Service Tool
Interface
(continued)
Rotary Switch Time Ramp
Parameters to set ramping time for incoming (scaled) signal:
y EE_RotSwTimeR_Range
y EE_RotSwTimeR_DecTime
y EE_RotSwTimeR_IncTime