Danfoss PLUS+1 - System 0, 1, 2, or 3

Technical Information Transit Mixer Controller (TMC)
11061324 • Rev CA • Sep 2013
16
System 0, 1, 2, or 3
The system screens have hyperlinks to the different parameter setting screens, some basic screens,
and some advanced screens where you can set the parameters in a graph. These different pages can
also be reached from the hyperlinks in the log page. All the values in System 0 are set to 0 since this is
not in use. When the system is 0 it means that it is a remote unit: only connected to system by the
machine CAN bus.
Service Tool
Interface
(continued)