Danfoss VLT 2800 User Manual

Dynamic braking 23
E
Earth connection 1
Earth leakage current 2
Earthing 42
Earthing of screened/armoured control cables 1
Efficiency 2
Electrical installation 1
Electrical installation, control cables 1
EMC compliant cables 44
EMC emission 2
EMC Immunity 2
EMC standards 2
EMC-correct electrical installation 1
ETR - Electronic Thermal Relay 73
Extra protection 42
Extreme operating conditions 2
F
Fan control 76
Fault log 130
Feedback 99
Feedback conversion 105
feedback range 98
Feedback, 96
Fieldbus 2
Fieldbus option 11
Flying start 104
Four Setups 60
Frequence bypass, bandwidth 84
Function at stop 71
G
Gain AC brake 76
Galvanic Isolation (PELV) 2
H
Hand Auto 1
Hand operation 66
Handling of references 2
Harmonics 2
High voltage test 42
High voltage warning 1
High voltage warning 42
I
Initialise 131
Integration 41
IT mains 50
J
Jog frequency 81
Jog ramp time 80
L
Language 59
Large display readout 61
LC filter 14
LCP 1
LCP copy 61
Leakage reactance 75
Literature 155
Load compensation 74
Load sharing 1
Local reference 59
Lock for data changes 65
Lowpass filter 99
M
mains cable 42
Mains connection 1
Mains protector 6
Mains supply 3
Mains voltage 9
Manual initialisation 1
Manual initialisation 36
Maximum Pulse 29 92
MCT 10 21
Mechanical brake 1
Mechanical brake 57
Mechanical installation 1
Menu mode 30
Menu mode 30
Motor cables 1
Motor coils 1
Motor coils 38
Motor connection 1
164 MG.27.E2.02 - VLT is a registered Danfoss trademark

Danfoss VLT 2800 Specifications

General

Frequency	50/60 Hz
Enclosure	IP20
Input Voltage	200-240V AC
Output Power Range	0.37-2.2kW
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short Circuit
Communication Interface	RS485
Operating Temperature	-10°C to +40°C
Storage Temperature	-25°C to +65 °C
Relative Humidity	5 - 95% RH, non-condensing
Output Voltage	0 - 100% of supply voltage