Danfoss VLT 5000-P User Manual

6-9
VLT is a registered Danfoss trademark
Mounting screws
(Step 6)
6. Remove soft charge resistor by removing two
mounting screws.
Reassembly
1. Clean heatsink surface with mild solvent or alcohol
solution.
2. Reassemble remaining parts in reverse order of
their removal. Tighten T25 and 8mm mounting
screws to 20 in-lbs (2.25 Nm) and T30 and 10
mm to 35 in-lbs (4 Nm).
Soft Charge Resistor
Figure 6-8. D1 Soft Charge Resistor (3 of 3)

Danfoss VLT 5000-P Specifications

General

Brand	Danfoss
Model	VLT 5000-P
Category	DC Drives
Language	English