Illustration 5.5: Recommended lifting method, frame size
F1.
Illustration 5.6: Recommended lifting method, frame size
F2.
Illustration 5.7: Recommended lifting method, frame size
F3.
Illustration 5.8: Recommended lifting method, frame size
F4.
NB!
Note the plinth is provided in the same packaging as the frequency converter but is not attached to F1-F4 frames during shipment.
The plinth is required to allow airflow to the drive to provide proper cooling. The F frames should be positioned on top of the plinth in
the final installation location. The angle from the top of the drive to the lifting cable should be 60 degrees or greater.
5.2.5 Tools Needed
To perform the mechanical installation the following tools are needed:
• Drill with 10 or 12 mm drill
• Tape measure
VLT
®
AQUA Drive Design Guide 5 How to Install
MG.20.N5.02 - VLT
®
is a registered Danfoss trademark
115
5
To Next Page
Loading...
