Danfoss VLT AQUA Drive Series - Page 130

5.3.8 Access to Control Terminals
All terminals to the control cables are located underneath the terminal cover on the front of the frequency converter. Remove the terminal cover by means
of a screwdriver (see illustration).
Illustration 5.17: Frame sizes A1, A2, A3,B3, B4, C3 and C4
Illustration 5.18: Frame sizes A5, B1, B2, C1 and C2
5.3.9 Control Terminals
Drawing reference numbers:
1. 10 pole plug digital I/O.
2. 3 pole plug RS485 Bus.
3. 6 pole analog I/O.
4. USB Connection.
Illustration 5.19: Control terminals (all enclosures)
5.3.10 Control Cable Terminals
To mount the cable to the terminal:
1. Strip isolation of 9-10 mm
2.
Insert a screw driver
1)
in the square hole.
3. Insert the cable in the adjacent circular hole.
4. Remove the screw driver. The cable is now mounted to the ter-
minal.
To remove the cable from the terminal:
1.
Insert a screw driver
1)
in the square hole.
2. Pull out the cable.
5 How to Install VLT
®
AQUA Drive Design Guide
130 MG.20.N5.02 - VLT
®
is a registered Danfoss trademark
5