Danfoss VLT AutomationDrive FC 301 User Manual

Parallel Connection Of Motors 41
Potentiometer Reference 35
Preset Reference 3-10 56
Profibus 3
Protection 29
Protection And Features 99
Protection Mode 8
Pulse Start/stop 34
Pulse/encoder Inputs 96
R
Ramp 1 Ramp Down Time 3-42 48
Ramp 1 Ramp Up Time 3-41 48
Reference Resource 1 3-15 56
Reference Resource 2 3-16 57
Reference Resource 3 3-17 57
Relay Outputs 63
Relay Outputs 97
Release Brake Current 2-20 54
Removal Of Knockouts For Extra Cables 22
Repair Work 9
Residual Current Device 9
Rfi Filter 14-50 69
S
Safe Stop 9
Safety Precautions 7
Screened/armoured 21, 26, 37
Serial Communication 97
Shaft Performance Levels. 3
Side-by-side Installation 18
Sine-wave Filter 29
Software Version 15-43 69
Speed Up/down 35
Start/stop 34
Stator Leakage Reactance 47
Status Messages 43
Stop Delay 2-24 54
Surroundings 98
Switches S201, S202, And S801 38
Symbols 4
T
Terminal 27 Mode 5-01 58
Terminal 29 Mode 5-02 58
Thermistor 50
Thermistor Source 1-93 51
Torque Characteristics 1-03 49, 95
Torque Ramp Time 2-27 55
Torque Ref 2-26 55
V
Voltage Level 95
Voltage Reference Via A Potentiometer 35
W
Warnings 101
Index
VLT
®
AutomationDrive FC 300 Operating
Instructions
112 MG.33.AG.02 - VLT
®
is a registered Danfoss trademark

Danfoss VLT AutomationDrive FC 301 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 301
Category	DC Drives
Language	English