Danfoss VLT AutomationDrive FC 302 Instruction Manual

6.1 How to Program the Adjustable Frequency Drive
52
6.1.1 Quick Set-up Parameters 52
6.1.2 Basic Set-up Parameters 55
6.2 How to Program the Active Filter
77
6.2.1 Using the Low Harmonic Drive in NPN Mode 77
6.3 Parameter Lists - Adjustable Frequency Drive
78
6.3.1 Parameter Selection 78
6.4 Parameter Lists - Active Filter
110
7 Application Examples
119
7.1 Introduction
119
7.2 Application Examples
119
7.3 Connection Examples for Control of Motor with External Signal Provider
124
7.3.1 Start/Stop 124
7.3.2 Pulse Start/Stop 124
7.3.3 Speed Up/Down 125
7.3.4 Potentiometer Reference 125
8 Status Messages
126
8.1 Status Display
126
8.2 Status Message Definitions
126
9 Warnings and Alarms
129
9.1 System Monitoring
129
9.2 Warning and Alarm Types
129
9.2.1 Warnings 129
9.2.2 Alarm Trip 129
9.2.3 Alarm Trip Lock 129
9.3 Warning and Alarm Displays
129
9.4 Warnings and Alarm Definitions - Adjustable Frequency Drive
130
9.5 Warning and Alarm Definitions - Filter (Left LCP)
139
10 Basic Start-up Troubleshooting
146
11 Specifications
149
11.1 Power-Dependent Specifications
149
11.1.1 Line Power Supply 3x380–480 V AC 149
11.1.2 Derating for Temperature 152
11.2 Mechanical Dimensions
153
11.3 General Technical Data - Adjustable Frequency Drive
156
Contents Instruction Manual
MG37A222 Danfoss A/S © Rev. 2014-02-07 All rights reserved.

Danfoss VLT AutomationDrive FC 302 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 302
Category	DC Drives
Language	English