5.1.12 PC Software Tools
PC-based Configuration Tool MCT 10 Set-up Software
The Low Harmonic Drive is equipped with two serial
communication ports. Danfoss provides a PC tool for
communication between PC and adjustable frequency
drive, MCT 10 Set-up Software. Check chapter 2.4 Additional
Resources for detailed information on this tool.
MCT 10 set-up software
MCT 10 is an interactive tool for setting parameters in
Danfoss adjustable frequency drives.
The MCT 10 set-up software is useful for:
•
Planning a communication network offline. MCT
10 contains a complete adjustable frequency
drive database
•
Commissioning adjustable frequency drives online
•
Saving settings for all adjustable frequency drives.
•
Replacing an adjustable frequency drive in a
network.
•
Simple and accurate documentation of adjustable
frequency drive settings after commissioning.
•
Expanding an existing network
•
Future developed adjustable frequency drives are
supported
MCT 10 set-up software supports Profibus DP-V1 via a
Master class 2 connection. It enables online read/write
parameters in an adjustable frequency drive via the
Profibus network, eliminating the need for an extra
communication network.
Save adjustable frequency drive settings
1. Connect a PC to the unit via the USB COM port.
CAUTION
Use a PC, which is isolated from the line power, with the
USB port. Failure to do so can damage equipment.
2. Open MCT 10 Set-up Software
3. Select “Read from drive”
4. Select “Save as”
All parameters are now stored on the PC.
Load adjustable frequency drive settings
1. Connect a PC to the adjustable frequency drive
via the USB com port
2. Open MCT 10 Set-up software
3. Select “Open” to show stored files
4. Open the appropriate file
5. Select “Write to drive”
All parameter settings are now transferred to the
adjustable frequency drive.
User Interface Instruction Manual
MG37A222 Danfoss A/S © Rev. 2014-02-07 All rights reserved. 51
5 5
To Next Page
Loading...
Need help?
General