Danfoss VLT CANopen MCA 105 - Page 34

8-19 Product Code
Range: Function:
Size
related*
[0 -
2147483647]
Select 0 to read out the actual
eldbus product code according
to the mounted eldbus option.
Select 1 to read out the actual
vendor ID.
8-46 BTM Transaction Status
Option: Function:
[0] * O
[1] Transaction Started
[2] Transaction Comitting
[3] Transaction Timeout
[4] Err. Non-existing Par.
[5] Err. Par. Out of Range
[6] Transaction Failed
8-47 BTM Timeout
Range: Function:
60 s* [1 - 360 s] Select the BTM timeout after a BTM
transaction has been started.
8-48 BTM Maximum Errors
Range: Function:
21* [0 - 21] Selects the maximum allowed number of bulk
transfer mode errors before aborting. If it is set to
maximum, there is no abort.
8-50 Coasting Select
Option: Function:
Select control of the coasting function via the
terminals (digital input) and/or via the bus.
[0] Digital
input
Activates start command via a digital input.
[1] Bus Activates start command via the serial
communication port or eldbus option.
[2] Logic AND Activates start command via the eldbus/serial
communication port, and 1 extra digital input.
[3] * Logic OR Activates start command via the eldbus/serial
communication port, or via 1 of the digital
inputs.
8-51 Quick Stop Select
Select control of the quick stop function via the terminals (digital
input) and/or via the bus.
Option: Function:
[0] Digital input
[1] Bus
[2] Logic AND
[3] * Logic OR
8-52 DC Brake Select
Option: Function:
Select control of the DC brake via the terminals
(digital input) and/or via the eldbus.
NOTICE
When parameter 1-10 Motor Construction is
set to [1] PM non-salient SPM, only selection
[0] Digital input is available.
[0] Digital
input
Activates start command via a digital input.
[1] Bus Activates start command via the serial communi-
cation port or eldbus option.
[2] Logic
AND
Activates start command via the eldbus/serial
communication port, and additionally via 1 of the
digital inputs.
[3] Logic OR Activates start command via the eldbus/serial
communication port, or via 1 of the digital inputs.
8-53 Start Select
Option: Function:
Select control of the frequency converter start
function via the terminals (digital input) and/or
via the eldbus.
[0] Digital
input
Activates a start command via a digital input.
[1] Bus Activates a start command via the serial
communication port or eldbus option.
[2] Logic
AND
Activates a start command via the eldbus/serial
communication port, and additionally via 1 of
the digital inputs.
[3] * Logic OR Activates a start command via the eldbus/serial
communication port, or via 1 of the digital
inputs.
8-54 Reversing Select
Option: Function:
[0] Digital
input
Select control of the frequency converter reverse
function via the terminals (digital input) and/or
via the eldbus.
[1] Bus Activates the reverse command via the serial
communication port or eldbus option.
[2] Logic AND Activates the reverse command via the eldbus/
serial communication port, and additionally via 1
of the digital inputs.
[3] Logic OR Activates the reverse command via the eldbus/
serial communication port, or via 1 of the digital
inputs.
Parameters
VLT
®
CANopen MCA 105
32 Danfoss A/S © 06/2015 All rights reserved. MG92G102
6
6