Danfoss VLT FC 100 Series User Manual

8-90 Bus Jog 1 Speed
Range: Function:
100
RPM
*
[0 - par. 4-13 RPM] Enter the jog speed. This is a fixed jog speed activated via the
serial port or fieldbus option.
8-91 Bus Jog 2 Speed
Range: Function:
200
RPM
*
[0 - par. 4-13 RPM] Enter the jog speed. This is a fixed jog speed activated via the
serial port or fieldbus option.
10-00 CAN Protocol
Option: Function:
[0] CANopen
[1]
*
DeviceNet View the active CAN protocol.
NB!
The options depend on installed option.
10-01 Baud Rate Select
Option: Function:
[16] 10 Kbps
[17] 20 Kbps
[18]
[19]
50 Kbps
100 Kbps
[20]
*
125 Kbps
[21] 250 Kbps
[22] 500 Kbps Select the fieldbus transmission speed. The selection must cor-
respond to the transmission speed of the master and the other
fieldbus nodes.
10-02 MAC ID
Range: Function:
63
*
[0 - 127 ] Selection of station address. Every station connected to the
same DeviceNet network must have an unambiguous address.
10-05 Readout Transmit Error Counter
Range: Function:
0
*
[0 - 255] View the number of CAN control transmission errors since the
last power-up.
6. Parameters FC 100/ 200/ 300 DeviceNet
58 MG.33.D3.02 - VLT
®
is a registered Danfoss trademark
6

Danfoss VLT FC 100 Series Specifications

General

Brand	Danfoss
Model	VLT FC 100 Series
Category	DC Drives
Language	English