5 Parameter Lists
5.1 Parameter Options
5.1.1 Default Settings
Changes during operation
True: The parameter can be changed while the frequency
converter is in operation.
False: The parameter can only be changed when the
frequency converter stops.
2-Set-up
All set-ups: The parameter can be set individually in each
of the 2 set-ups. 1 single parameter can have 2
dierent
data values.
1 set-up: Data value is the same in all set-ups.
ExpressionLimit
Size-related
N/A
No default value available.
Conversion index
This number refers to a conversion gure used when
writing or reading via a frequency converter.
Conv.
index
100 75 74 70 67 6 5 4 3 2 1 0 -1 -2 -3 -4 -5 -6
Conv.
factor
1 3600000 3600 60 1/60 1000000 100000 10000 1000 100 10 1 0.1 0.01 0.001 0.0001 0.00001 0.000001
Data type Description Type
2 Integer 8 Int8
3 Integer 16 Int16
4 Integer 32 Int32
5 Unsigned 8 Uint8
6 Unsigned 16 Uint16
7 Unsigned 32 Uint32
9 Visible string VisStr
33 Normalized value 2 bytes N2
35 Bit sequence of 16 boolean variables V2
Table 5.1 Data Type
Parameter Lists Programming Guide
MG18B502 Danfoss A/S © 04/2018 All rights reserved. 105
5 5
To Next Page
Loading...
