Danfoss VLT Micro Drive FC 51 Series - Brakes

Parameter Number Parameter Description Default Value 2 Setup Change During Operation Conversion Index Type 2 - 00 DC Hold Current 50% All set-ups TRUE 0 Uint16
2 - 01 DC Brake Current
50% All set-ups TRUE
0 Uint16
2 - 02 DC Braking Time 10 s All set-ups TRUE -1 Uint16
2 - 04 DC Brake Cut In Speed
0 Hz All set-ups TRUE
-1 Uint16
2 - 10 Brake Function [0] Off All set-ups TRUE - Uint8
2 - 11 Brake Resistor (ohm)
All set-ups TRUE
0 Uint16
2 - 16 AC Brake, Max current 100% All set-ups TRUE 0 Uint16
2 - 17 Over-voltage Control
[0] Disabled All set-ups TRUE
- Uint8
2 - 20 Release Brake Current 0 A All set-ups TRUE -2 Uint32
2 - 22 Activate Brake Speed [Hz]
0 Hz All set-ups TRUE
-1 Uint16
5.2.7. 2-** Brakes
5. Parameter Lists VLT
p
Micro Drive FC 51
70 MG.02.C4.02 - VLT
p
is a registered Danfoss trademark
5