Danfoss VLT Micro Drive FC 51 Series - Comm. and Options

Parameter Number Parameter Description Default Value 2 Setup Change During Operation Conversion Index Type 8 - 01 Control Site [0] Digital and ctrl.word All set-ups TRUE - Uint8
8 - 02 Control Word Source
[1] FC RS485 All set-ups TRUE
- Uint8
8 - 03 Control Word Timeout Time 1 s 1 set-up TRUE -1 Uint16
8 - 04 Control Word Timeout Function
[0] Off 1 set-up TRUE
- Uint8
8 - 06 Reset Control Word Timeout [0] No function 1 set-up TRUE - Uint8
8 - 30 Protocol
[0] FC 1 set-up TRUE
0 Uint8
8 - 31 Address 1 1 set-up TRUE 0 Uint8
8 - 32 FC Port Baud Rate
[2] 9600 Baud 1 set-up TRUE
- Uint8
8 - 33 FC Port Parity [0] Even Parity 1 Stop Bit 1 set-up TRUE - Uint8
8 - 35 Minimum Response Delay
0.01 s 1 set-up TRUE
-3 Uint16
8 - 36 Max Response Delay 5 s 1 set-up TRUE -3 Uint16
8 - 50 Coasting Select
[3] Logic OR All set-ups TRUE
- Uint8
8 - 51 Quick Stop Select [3] Logic OR All set-ups TRUE - Uint8
8 - 52 DC Brake Select
[3] Logic OR All set-ups TRUE
- Uint8
8 - 53 Start Select [3] Logic OR All set-ups TRUE - Uint8
8 - 54 Reversing Select
[3] Logic OR All set-ups TRUE
- Uint8
8 - 55 Set-up Select [3] Logic OR All set-ups TRUE - Uint8
8 - 56 Preset Reference Select
[3] Logic OR All set-ups TRUE
- Uint8
8 - 94 Bus feedback 1 0 All set-ups TRUE 0 Int16
5.2.13. 8-** Comm. and Options
5. Parameter Lists VLT
p
Micro Drive FC 51
76 MG.02.C4.02 - VLT
p
is a registered Danfoss trademark
5