in the adjustable frequency drive and opposite. If the switching frequency is increased compared to the default setting, the power losses may
rise significantly.LCP and typical control card power consumptions are included. Further options and customer load may add up to 30W to the
losses. (Though typical only 4W extra for a fully loaded control card, or options for slot A or slot B, each).
Although measurements are made with state of the art equipment, some measurement inaccuracy must be allowed for (+/-5%).
8 Specifications VLT
®
HVAC Drive Instruction Manual
8-14
MG.11.A9.22 - VLT
®
is a registered Danfoss trademark
8
To Next Page
Loading...
