Programmable SyncPos motion controller
MG.10.J8.02 – VLT is a registered Danfoss trade mark
20
Fundamentals of the SyncPos program
SyncPos is a Windows based development system with a programming language
specially designed for synchronizing and positioning control which is easy to learn,
the commands of which are based on frequently used control terminology. This
macro-language makes it possible to realize complex functions with simple
commands even without knowledge of the hardware processes and thus create
control programs and general control programs in a very short time.
The SyncPos software contains all commands and menus necessary for the
configuration, programming, optimization and, finally, for the transfer of
commands to the SyncPos motion controller.
To Next Page
Loading...
