Danfoss VLT5000 SyncPos

81
MG.10.J8.02 – VLT is a registered Danfoss trade mark
Programmable SyncPos motion controller
Chapter 5 a
■■
■■
■ PC Software Interface in MTC10 Mode
■■
■■
■ Operation Mode: Offline or Online ........................... 83
■■
■■
■ Opening SyncPos in MCT10 Mode .......................... 83
■■
■■
■ Closing SyncPos in MCT10 Mode ............................ 83
Manual closing................................................................................ 83
Automatic closing ......................................................................... 83
■ File Handling ..................................................................... 83
■ "FILE" menu in MCT10 Mode ...................................... 84
"FILE" → "NEW"...............................................................................84
"FILE" → "OPEN" ............................................................................84
"FILE" → "SAVE AS" .....................................................................84
"FILE" → "PRINT" and → "PRINT SETUP" ...................84
"FILE" → "LAST FILE" ..................................................................84
■ "DEVELOPMENT" menu in MCT10 Mode............... 84
Online Mode .......................................................................................84
Offline Mode ........................................................................................84
"DEVELOPMENT" → "SYNTAX CHECK" ........................84
"DEVELOPMENT" → "COMMAND LIST" ........................84
■ CAM Editor in MCT10 Mode ....................................... 85
■ CAM-Editor window without curve data ................. 85
"FILE" menu (CAM-Editor) in MCT10 Mode ...................85
"EDIT" menu (CAM-Editor) in MCT Mode .......................86
"VIEW" menu (CAM-Editor) in MCT Mode......................86
■ "SETTINGS" menu in MCT10 mode .......................... 86
PC Software Interface in MTC10 Mode