Danfoss VLT5000 SyncPos - PC Software Interface

49
MG.10.J8.02 – VLT is a registered Danfoss trade mark
Programmable SyncPos motion controller
Chapter 5 ■ PC Software Interface
■ "FILE" menu
"NEW" ..................................................................................................... 51
"OPEN" .................................................................................................. 51
"CLOSE"................................................................................................ 51
"SAVE" and "SAVE AS" ..............................................................52
Printing and printer settings ...................................................52
"EXIT PROGRAM".........................................................................52
Delete File............................................................................................52
■ "EDIT" menu
"UNDO" .................................................................................................53
"CUT" ......................................................................................................53
"COPY" and "PASTE" .................................................................53
"FIND" and "REPLACE"..............................................................53
■ "DEVELOPMENT" menu
"EXECUTE" ...........................................................................................54
Run programs in several VLTs ................................................55
"BREAK" ................................................................................................55
"CONTINUE" program .................................................................55
Preparing "SINGLE-STEP" ........................................................55
Set Breakpoints .................................................................................55
Change and read variables online.....................................56
"GO" (Debug) and "SINGLESTEP" .....................................56
"END DEBUG" ..................................................................................56
"SHOW WATCH" ..............................................................................56
"SYNTAX CHECK" .......................................................................... 57
"COMPILE TO FILE" ....................................................................... 57
"BREAK ALL" ...................................................................................... 57
"SELECT CONTROLLER" ........................................................... 57
"CLOSE INTERFACE" ................................................................... 57
"COMMAND LIST".......................................................................... 57
"POSITION DRIVE" (Teach-in-programming) ...............58
■ "CONTROLLER" menu
"PROGRAMS" ....................................................................................58
"AUTOSTART" ....................................................................................59
"CONTROLLER"
→→
→→
→ "PARAMETERS" ..................................60
Global parameters ..........................................................................60
Axis parameters ............................................................................... 61
Set or change axis parameters online .............................
61
How to change parameters of a configuration file ...62
"PARAMETERS"
→→
→→
→ "NAME" ....................................................63
"PARAMETERS"
→→
→→
→ "SAVE TO FILE" ..................................63
"PARAMETERS"
→→
→→
→ "RESTORE FROM FILE" .................63
"MEMORY"
→→
→→
→ … ............................................................................63
"RESET"
→→
→→
→ … ...................................................................................64
PC Software interface