Danfoss VLT5000 SyncPos User Manual

Programmable SyncPos motion controller
MG.10.J8.02 – VLT is a registered Danfoss trade mark
82
SyncPos behaves different, if started directly by clicking on the application’s icon
or if started indirectly by opening up a program or configuration file via the
Motion Control Tool MCT10. The main differences are related to the fact that all file
handling is limited to MCT10 only. These limitations concerning the SyncPos GUI are
explained in this chapter, e.g. how to open and save files or how to edit a cnf-curve or
set parameters.
The following chapter describes the differences in the SyncPos User Interface, when
running in MCT10 Mode, for example the file handling or editing a CAM curve. In
addition the user interface is different depending of the mode of operation: Offline or
Online Mode.
PC Software Interface in MTC10 Mode

Danfoss VLT5000 SyncPos Specifications

General

Category	Controller
Frequency	50/60 Hz
Series	VLT5000
Control Method	Vector control
Communication	CANopen
Enclosure Rating	IP20
Storage Temperature	-25°C to 70°C
Altitude	Up to 1000m above sea level
Humidity	5% to 95% (non-condensing)