Danfoss VLT5000 SyncPos User Manual

Programmable SyncPos motion controller
MG.10.J8.02 – VLT is a registered Danfoss trade mark
212
Messages and Error Reference
■ Error in array ...
SyncPos
Error in array part of file.
Meaning
When re-saving a configuration ("CONTROLLER"
→→
→→
→ "PARAMETERS"
→→
→→
→ "RESTORE FROM FILE")
the computer recognizes that the data in the array
area is formatted incorrectly.
Cause
In order to be able to save a file, the following
conditions must be fulfilled:
• Identical software versions
• same configuration (e.g. same number of
axes)
• In the case that arrays have already been in-
putted, these must match the ones that are to
be saved in terms of type and size.
■ Error in axis parameter ...
SyncPos
Error in axis parameter part of file.
Meaning
When re-saving a configuration ("CONTROLLER"
→→
→→
→ "PARAMETERS"
→→
→→
→ "RESTORE FROM FILE")
the computer recognizes that the data in the area
of the axis parameters is formatted incorrectly. The
parameter number and the sequence must be cor-
rect and numbering must be continuous.
Cause
In order to be able to save a file, the following
conditions must be fulfilled:
• Identical software versions, that provides
same number and order of the parameters
• same configuration (e.g. same number of
axes)
■ Error in global parameter ...
SyncPos
Error in global parameter part of file.
Meaning
When re-saving a configuration ("CONTROLLER"
→→
→→
→ "PARAMETERS"
→→
→→
→ "RESTORE FROM FILE")
the computer recognizes that the data in the area
of the global parameters is formatted incorrectly.
Causes
In order to be able to save a file, the following
conditions must be fulfilled:
• Identical software versions, that provides
same number and order of the parameters
• same configuration (e.g. same number of
axes)
■ Lost connection to ...
SyncPos
Lost connection to #%d!
Meaning
If the VLT is turned off or the plug is pulled, etc.
the window is disconnected from the VLT and the
lost connection is registered.
■■
■■
■ Timeout: no reply from VLT
SyncPos
Timeout: no reply from VLT
Meaning
The VLT does not answer; check the connection.

Danfoss VLT5000 SyncPos Specifications

General

Category	Controller
Frequency	50/60 Hz
Series	VLT5000
Control Method	Vector control
Communication	CANopen
Enclosure Rating	IP20
Storage Temperature	-25°C to 70°C
Altitude	Up to 1000m above sea level
Humidity	5% to 95% (non-condensing)