Danfoss VLT5000 SyncPos User Manual

Programmable SyncPos motion controller
MG.10.J8.02 – VLT is a registered Danfoss trade mark
2
Programmable SyncPos motion controller
for
VLT
®
5000 and
VLT
®
5000Flux
This instruction manual covers two versions of the programmable SyncPos motion controller:
Ordering number Description Type code
175Z0833 SyncPos for VLT5000 A10 C0
175Z3029 SyncPos for VLT5000 with conformal coating A10 C1
175Z3683 SyncPos for VLT5000Flux A10 C0
175Z3684 SyncPos for VLT5000Flux with conformal coating A10 C1
The basic functionality of the two versions is the same, the only differences are:
• The Flux version has two additional outputs on the VLT5000Flux control card.
• The Flux version does not yet support absolute encoders.
This instruction manual is valid for the following software versions:
SyncPos PC software version 6.5X
VLT5000/SyncPos software version 3.7/5.0X
VLT5000Flux/SyncPos software version 5.XX/5.0X
Software version
© Danfoss A/S 2004
VLT is a registered Danfoss trademark.
IBM is a registered trademark of International Business Machines, Inc.
Microsoft, MS, MS-DOS, Microsoft NT, Windows and Wingdings are either registered trademarks or
trademarks of the Microsoft Corporation in the USA and/or other countries.

Danfoss VLT5000 SyncPos Specifications

General

Category	Controller
Frequency	50/60 Hz
Series	VLT5000
Control Method	Vector control
Communication	CANopen
Enclosure Rating	IP20
Storage Temperature	-25°C to 70°C
Altitude	Up to 1000m above sea level
Humidity	5% to 95% (non-condensing)