15
For Days 1-5 (weekdays)
a) Press PROG until Event 1 ashes in
display (Event 1, Days 1,2,3,4,5).
b) Use + and – buttons to alter time
(press and hold to change in 10 min
increments).
c) Use and buttons to alter the water
temperature in 0.5°C (1°F) steps.
d) Press NEXT to move to next preset time &
temperature (Event 2, Days 1,2,3,4,5).
e) Repeat steps b, c & d for programming
Events 3, 4, 5 & 6.
For Days 6-7 (weekends)
Press PROG until Event 1 ashes in
display (Event 1 Days 6-7).
Repeat steps b, c and d above to
programme time and temperature
events for the weekend.
Press PROG until the colon in the LCD display
starts to ash.
The unit is now in RUN mode and your
hot water will come on and go o at the
programmed times.
Proceed to page 16.
Programming in 5/2 day mode
(one set of programmes for weekdays, another set for weekends)
Programming in 5/2-day mode
To Next Page
Loading...
