10.2.1.9 Set max delegate speakers
max_speakers <max speakers><CR>
Maximum number of delegates allowed to speak.
<max speakers> Can be set to “1” to “8”
The CU responds by sending a 'max_speakers' command.
10.2.1.10 Set max requests
max_requests <max requests><CR>
Maximum number of delegates allowed in the request list.
<max requests> Can be set to “0” to “250”.
The CU responds by sending a 'max_requests’ command.
10.2.1.11 Set operation mode
mic_mode <mode><CR>
Set system operation mode.
<mode> Can be set to “auto” (Automatic), “fifo” (First-in-first-out), “manual” (Manual) and “vox” (Voice Active)
The CU responds by sending a ‘mic_mode’ command.
10.2.1.12 Set interrupt mode
mic_interrupt <mode><CR>
Set ability to interrupt. Defines, whether microphones should interrupt or not.
<mode> Can be “on” (microphones interrupt) and “off” (microphones do not interrupt)
The CU responds by sending a ‘mic_interrupt’ command
10.2.1.13 Retrieve microphone status
mic_status<CR>
Ask the cu to deliver status of the system (microphones in speak, and microphones in request list).
The CU responds by sending microphone system status. The status is a list of commands from the CU:
seat_number (for all microphones in the system)
mic_mode
mic_interrupt
max_total_speakers
max_speakers
max_requests
To Next Page
Loading...