6 Commissioning
6.2 Configuration Filtertime
The following must be available for the device configuration:
• USB driver CDM21228 (Download Link) - Installed on PC
• Configuration Tool DATAEAGLE Wizard (Download Link) - Installed on PC
• USB cable - between PC and DATAEAGLE
Connect DATAEAGLE to the PC via the USB cable and start the DATAEAGLE
Wizard configuration software.
Select Autodetect COM Port and then Connect to connect to DATAEAGLE
and read the configuration. The DATAEAGLE must be switched on for this.
Manual
DATAEAGLE 4000 Series - Wireless ETHERNET
28
To Next Page
Loading...