-6-
13) Select Communication>E-mail tab. This page contains E-mail related parameters.
14) SMTP field should be filled appropriately. This is the e-mail address from where the unit
will send e-mail messages. The information is the same as used in a computer.
15) Select E-mail on IP Change parameter as required. If this parameter is enabled, the D-
500/700 device will send an e-mail message each time the IP is changed.
16) Select E-mail on Mains Change parameter as required. If this parameter is enabled, the
D-500/700 device will send an e-mail message each time the mains status is changed.
17) E-mail address 1 (2/3) is the address to where e-mail messages will be sent. If e-mails
are required, enter your e-mail addresses here. If e-mails are not required, then enter
blank fields here. The unit can send up to 3 e-mails at once.
The unit will come with ready to use SMTP parameters.
It is possible to use the unit without any modificaiton to the SMTP field.
The originating e-mail address programmed in the SMTP field must be an
activated address.
Otherwise the unit will fail to open a session in this server and cannot send
e-mail messages.
To Next Page
Loading...
General