DataLocker DL3 - Admin password

9"
!
!
!
ADMINISTRATOR PASSWORD
The process of changing the administrator password is identical to the setup
process. It is highly recommended that you set a new administrator password
using alphanumeric characters.
Step 1: Power on your DL3™ by
plugging it in to your computer. If the
drive is already connected, press the
[DISCONNECT] button and then press
the [CONNECT] button on the next
screen.
Step 2: Once at the
keypad screen,
enter the admin
password. If the
password has not
been changed,
enter the default
Step 3: Press the
[SETUP] button on the
touch screen. If the
[SETUP] button is not
selected within 3
seconds, the
DataLocker DL3™ will
password, 000000, and press the [↵]
symbol.
automatically connect to the host
computer.
Step 4: At the setup menu press the [CHANGE PASSWORD]
button.