DataLocker DL4 FE - Touch Sounds; Brightness; Read-Only Mode; Language

DL4 FE Encrypted External Hard Drive - v1.49/6.5.0 - User Guide
Touch Sounds
The DL4 touch sounds are enabled by default.
To disable these sounds, follow these steps:
1. Tap the Touch Sounds feature from the administrator menu.
2. Tap the Disable button.
3. Tap Back from the upper left to save and exit to the administrator menu.
Brightness
Your DL4 screen brightness can be adjusted via this feature. The default value is 10.
To change the value, follow these steps:
1. Tap the Brightness option from the administrator menu
2. Tap (+) to increase the brightness and (-) to decrease the brightness.
NOTE: The minimum brightness value can be 1 and maximum is 30.
3. Tap Back from the upper left to save and exit to the administrator menu.
Read-Only Mode
Administrators can select the Read-Only Mode to globally enforce the DL4 to always unlock in
read-only mode. Enabling this option will also enforce read-only access for the User profile (if the
user profile is enabled). Once the Read-Only Mode is enabled, data can only be read from the
DL4 and no data can be written or modified.
To enable Read-Only Mode, follow these steps:
1. Tap the Read-Only Mode feature from the administrator menu.
2. Tap Enable.
3. Tap Back from the upper left to save and exit to the administrator menu.
NOTE: The administrator and the user can each set Read-Only Mode for a single login by tapping
Read-Only Mode after entering the password. The Read-Only Mode will enforce this functionality
for every login.
Language
A total of 4 languages can be selected. The selected language will be used for all on board menu
prompts. The available languages are:
- English
- French
- German
- Spanish
To set a preferred language, follow these steps:
© 2021 DataLocker Inc. All rights reserved. 26