Compliance
18 Cobalto
TM
CO5300 Scanner
Compliance
See the section Laser Safety starting on page 25 for information
about laser safety compliance.
Regulatory Information
All models are designed to be compliant with rules and regula-
tions in locations they are sold and will be labeled as required.
Statement of Agency Compliance
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: {1} this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
FCC Compliance
The user is cautioned that changes or modifications not expressly
approved by the part responsible for compliance could void the
user’s authority to use the equipment.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communi-
cations. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit differ-
ent from that to which the receiver is connected.
• Consult the dealer or and experienced radio or television
technician for help.
To Next Page
Loading...
