Programming
Quick Reference Guide 13
Programming
The reader is factory-configured with a set of standard default fea-
tures or loaded with a custom configuration, depending upon the
model ordered. After scanning the interface bar code from the Inter-
faces section (if necessary), you can select other options and cus-
tomize your reader through use of the programming bar codes
available in the Gryphon I GPS4400 Product Reference Guide (PRG).
Programming can also be performed using the Datalogic Aladdin™
Configuration application, which is downloadable from the Datalogic
website listed on the back cover of this manual. This multi-platform
utility program allows device configuration using a PC. It communi-
cates with the device using a serial or USB cable, and can also create
configuration bar codes to print.
Using Programming Bar Codes
This manual contains bar codes which allow you to reconfigure your
reader. Some programming bar code labels, like Restore Custom
Default Settings on page 14, require only the scan of that single
label to enact the change.
Other bar codes require the reader to be placed in Programming
Mode prior to scanning them. Scan an ENTER/EXIT bar code once to
enter Programming Mode; scan the desired parameter settings;
scan the ENTER/EXIT bar code again to accept your changes, which
exits Programming Mode and returns the reader to normal opera-
tion.
Configure Other Settings
Additional programming bar codes are available in the PRG to allow
for customizing programming features. If your installation requires
different programming than the standard factory default settings,
refer to the PRG.
To Next Page
Loading...
Need help?
General