Datalogic Magellan 2200VS - Parity

128 Magellan
®
2200VS/2200VS and 2300HS/2300HS
RS-232 Parity
Specifies parity required for sending and receiving data.
Options for this setting are:
•
RS-232 PARITY = NONE
• RS-232 PARITY = EVEN
• RS-232 PARITY = ODD
To set this feature:
1. Scan the SWITCH bar code.
2. Scan the bar code below or on the following pages representing the
desired Parity setting. You’ll need to cover any unused bar codes, as
well as facing pages to ensure that the scanner reads only the bar
code you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
RS-232 PARITY = NONE
NOTE
8 data bits with 2 stop bits and parity enabled is not a valid configura-
tion.