Datalogic Magellan 3300HSi Quick Reference Guide

6 Magellan
TM
3300HSi
Momentary (when
scanner is awake)
Increments volume
Press the push button momen-
tarily to increase speaker vol-
ume. When the loudest volume
is reached, a repeated press of
the push button cycles volume
back to the lowest setting, then
volume increases on subsequent
press(es). Four volume levels
are available.
Hold, then release
when the beeper
sounds
Increments tone
Press the push button for
approximately 2 seconds, then
release. Each time this is done,
the beeper will sound at one of
three tones. Stop when the
desired tone (high, medium or
low) is sounded.
4 Seconds
Scanner Diagnostics
Mode
a
This mode allows system sup-
port personnel to troubleshoot
problems with the scanner and is
used to determine if it can read
bar codes. Press the button for
eight seconds or cycle power to
exit Scanner Diagnostics Mode
and reset the scanner.
8 Seconds
Resets Scanner
b
Only system support personnel
should perform a reset.
a. By standard default, this function is normally disabled to
prevent accidental activation by users.
b. Users should not perform scanner resets except under the
direction of trained systems support personnel.
Table 1. Scanner Push Button Functions
PRESS
DURATION
FUNCTION COMMENT

Datalogic Magellan 3300HSi Specifications

General

Scanner type	1D
Decoding standards	GS1, MicroPDF417, PDF417
Optical sensor resolution	1280 pixels
Light levels (direct sunlight)	0 - 86100 lx
Dimensions (WxDxH)	152 x 87 x 152 mm
Power consumption (active)	9.9 W
Standard interfaces	USB, RS-232
Input voltage	90 - 264 V
Power requirements	47 - 63 Hz
Power consumption (standby)	2 W
Certification	RoHS, EN 60825-1, IEC 60825, IEC 60825-1
Product color	Stainless steel
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
Harmonized System (HS) code	84716070

Weight and Dimensions

Weight	790 g