Datalogic Magellan 3300HSi Quick Reference Guide

Quick Reference Guide 13
Programming
Upon completing the physical connection between the reader and
its host, proceed directly to the Programming Bar Codes table
below to locate the interface type the reader is connected to (for
example: RS-232, Keyboard Wedge, USB, etc.).
Use the Bar Code Mask on the preceding page to isolate the bar
code you intend to scan. Scan a Start/End bar code once to enter
Programming Mode. After selecting (scanning) the interface, scan
the ENTER/EXIT barcode a second time, which will then accept
your changes, exit Programming Mode and return the reader to
normal operation.
You can select other options and customize your reader through
use of the instructions and programming barcodes available in the
PRG or use the On Screen Programming (OSP) utility available
from the website listed on the back cover of this manual.
START / END
PROGRAMMING BAR CODES
RS-232 Standard
RS-232 Wincor-Nixdorf

Datalogic Magellan 3300HSi Specifications

General

Scanner type	1D
Decoding standards	GS1, MicroPDF417, PDF417
Optical sensor resolution	1280 pixels
Light levels (direct sunlight)	0 - 86100 lx
Dimensions (WxDxH)	152 x 87 x 152 mm
Power consumption (active)	9.9 W
Standard interfaces	USB, RS-232
Input voltage	90 - 264 V
Power requirements	47 - 63 Hz
Power consumption (standby)	2 W
Certification	RoHS, EN 60825-1, IEC 60825, IEC 60825-1
Product color	Stainless steel
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
Harmonized System (HS) code	84716070

Weight and Dimensions

Weight	790 g