How to Scan
6
MAGELLAN™ 3510HSI
PRESS
DURATION
FUNCTION COMMENT
Momentary (when
scanner is asleep)
Wakes scanner from
Sleep Mode
Alternatively, the scanner can
be awakened by:
- Moving an object through the
scan zone.
- Scanning with an attached
auxiliary scanner.
Momentary (when
scanner is awake)
Increments volume
Press the button momentarily
to increase speaker volume.
When the loudest volume is
reached, a repeated press of the
button cycles volume back to
the lowest setting, then volume
increases on subsequent
press(es). Five volume levels
are available.
Hold, then release
when the beeper
sounds
Increments tone
Press the button for
approximately 2 seconds, then
release. Each time this is done,
the beeper will sound at one of
three tones. Stop when the
desired tone (high, medium or
low) is sounded.
4 Seconds
Scanner Diagnostics
Mode
a
This mode allows system
support personnel to
troubleshoot problems with the
scanner and is used to
determine if it can read bar
codes. Press the button for 10
seconds or cycle power to exit
Scanner Diagnostics Mode and
reset the scanner.
10 Seconds Resets Scanner
b
Only system support personnel
should perform a reset.
a. By standard default, this function is normally disabled to prevent accidental
activation by users.
b. Users should not perform scanner resets except under the direction of
trained systems support personnel.
To Next Page
Loading...
Need help?
General