5-2 Magellan
®
8300/8400
Return to Factory Settings
Scan this bar code to return the scanner to the default settings configured
at the factory for the currently active interface. This bar code is typically
used to return the scanner to a “known” operating state when the present
programming status is not known, faulty, or suspect.
RETURN TO FACTORY SETTINGS
CAUTION
Use this bar code with caution, since it will reset ALL features that may have
been programmed since the scanner’s installation.
NOTE
DO NOT scan the SWITCH bar code before and after scanning this bar code,
as the bar code below automatically enters and exits Programming Mode as
a part of its function. If this bar code is scanned following a SWITCH bar
code, it will simply cause the scanner to exit Programming Mode without
making changes.
To Next Page
Loading...
Need help?
General
