Scale Features
Technical Guide 5-3
Scale Features
Scale Enable
Use this feature to enable or disable scale operation.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan your selection from the two bar codes below. You’ll need to
cover any unused bar codes on this and the facing page to ensure
that the scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
SCALE = DISABLE
SCALE = ENABLE
NOTE
Recalibration/recertification may be required when adding scale functional-
ity. Consult your local Weights and Measures authority.
If this feature is enabled the scanner will expect that it is to function as a
scanner-scale, and will indicate an error if it is not a scale-equipped unit. See
Chapter 3, Error Codes, for more information.
To Next Page
Loading...
Need help?
General
